Editing Laser Cut Gainesville Hackerspace Keychains
Jump to navigation
Jump to search
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 1: | Line 1: | ||
Keychains are a great gift to give guests visiting the Hackerspace, and it is a great project to learn how to use the laser cutter. The GCode has already been created for a few different sizes of acrylic, so if you want to skip straight to cutting you can start with [[#Premade Gcode Files|Premade Gcode Files]]. | Keychains are a great gift to give guests visiting the Hackerspace, and it is a great project to learn how to use the laser cutter. The GCode has already been created for a few different sizes of acrylic, so if you want to skip straight to cutting you can start with [[#Premade Gcode Files|Premade Gcode Files]]. | ||
− | |||
− | |||
[[File:HackerspaceKeychains.jpg|border|right|400px|4 Keychains with Acrylic Paint]] | [[File:HackerspaceKeychains.jpg|border|right|400px|4 Keychains with Acrylic Paint]] | ||
[[File:KeychainsInHolder.jpg|border|right|350px|Keychains in Holder]] | [[File:KeychainsInHolder.jpg|border|right|350px|Keychains in Holder]] | ||
Line 13: | Line 11: | ||
GCode files have already been created for the following sizes of acrylic. Simply cut a piece of acrylic to one of the sizes (a bandsaw works great for that), and use the files listed. | GCode files have already been created for the following sizes of acrylic. Simply cut a piece of acrylic to one of the sizes (a bandsaw works great for that), and use the files listed. | ||
− | + | === 196mm x 156mm, 0.008" thickness. 15 count, 1h 20m cut time=== | |
− | |||
− | |||
− | |||
− | === | ||
Creates 15 keychains with Rulers. Uses the (-3,-3)mm jig. | Creates 15 keychains with Rulers. Uses the (-3,-3)mm jig. | ||
File locations: | File locations: | ||
− | * | + | * /machinekit/Desktop/Hackerspace Keychains/Ruler_15count_196x156mm_0pt008in_Engrave.nc |
− | * | + | * /machinekit/Desktop/Hackerspace Keychains/Ruler_15count_196x156mm_0pt008in_Cut.nc |
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
Line 73: | Line 49: | ||
# Close LinuxCNC, close VNC viewer. | # Close LinuxCNC, close VNC viewer. | ||
# Turn off power strip for the laser | # Turn off power strip for the laser | ||
− | |||
− | |||
− |